Set Up Guide

Thank you for purchasing the DOME
Door/Window Sensor, which works with your
Z-Wave Certified Controller to monitor doors,
windows, and other openings in your home.
SolidWorks Student Edition.
For Academic Use Only.
Screw Holes
Sensor Cover
Release Button
Button
Indicator LED
Reed
Switch
QR Code
Button Slot
Figure 1 - Door/Window Sensor Front
Including/Connecting into the Z-Wave Network:
Follow the instructions for your Z-Wave certified Controller
to enter inclusion mode.
When prompted by the Controller:
1. For proper inclusion, bring the Door/Window Sensor
to within 10 feet of your Controller. After inclusion, the
device can be moved to any desired location.
2. Remove the cover of the Door/Window Sensor.
3. Remove the Battery Tab.
4. Press the Connect Button quickly 3 times in a row.
The LED Indicator will flash five times indicating inclusion.
Excluding/Disconnecting from the Z-Wave Network:
Follow the instructions for your Z-Wave certified Controller to
enter exclusion mode.When prompted by the Controller:
1. Remove the Cover of the Door/Window Sensor.
2. Press the Connect Button quickly 3 times in a row.
The LED Indicator will flash five times indicating exclusion/dis-
connection.
Resetting the Door/Window Sensor to Factory Default
Settings:
To disconnect from the Z-Wave Network and restore factory default
settings:
1. Open the Cover and make sure the Door/Window Sensor is
powered.
2. Hold the Connect Button for 10 seconds until the LED Indicator
blinks once, then release the button.
Only do this if the controller is disconnected or otherwise unreach-
able!
Door/Window Sensor