Set Up Guide

ManualsBrandsDome ManualsHome AutomationDome Z-Wave Motion Sensor with Range Boost

WATER MAIN SHUT-OFF

SolidWorks Student Edition.

For Academic Use Only.

Open/Close

Button

Control Arm

Mounting Bracket

Motor Assembly

LED Indicator

Figure 1

Thank you for purchasing the Dome Z-Wave Water Main Shut-O, which works with

your Z-Wave Certied Controller to let you control your water main while on vacation,

or have it automatically shut o in case of leaks or other emergencies.

Including/Connecting into the Z-Wave Network:

1. For proper inclusion, bring the Water Main Shut-O to the nal location

where it will be used. *

2. Follow the instructions for your Z-Wave controller to enter inclusion mode.

3. Make sure the Water Main Shut-O is powered on, and when prompted by

your controller, press the “open/close” button quickly 3 times in a row. The

LED will stop blinking and stay on continuously upon successful inclusion.

CAUTION

Upon inclusion, the motor will engage and start turning automatically. To avoid serious injury, keep your ngers and

hands clear of the CONTROL ARM and its path, only gripping the unit rmly by either the MOUNTING BRACKET or the

top of the MOTOR ASSEMBLY.

*For non Z-Wave Plus networks, please consult the owner’s manual for your primary controller to determine the best method and location for adding

the Water Main Shut-O to your Z-Wave network.

Installation:

The Water Main Shut-O can be installed on

any preexisting ½” to 1 ½” brass ball valve, at

least 5” away from any walls or other obstruc-

tions. Examine Figure 3 and make sure there

is enough room in your plumbing installation to

accommodate the Shut-O.

1. Make sure the valve is comfortably usable

by hand before continuing further.

2. Unscrew the screws on both HOSE CLAMPS

completely so their ends are free, insert

both of them into the MOUNTING BRACKET,

and let them hang loosely.

3. Remove the protective lm covering the

CONTROL ARM screws and spread the CON-

TROL ARM.

4. Make sure both the ball valve and the Water

Main Shut-O are in the “open” position (where

the handle is inline with the pipe, not at a right

angle to it,) and slide the CONTROL ARM around

the valve’s handle (g 4.)

5. Loosely tighen the hose clamps around the

pipe on the opposite side of the valve handle so it

remains movable (g 3.)

(continued on next page)

5”+

5”

Hose Clamps

Figure 3

SolidWorks Student Edition.

For Academic Use Only.

Control

Arm

Valve

Handle

Figure 4

Summary of content (2 pages)

PAGE 1
Thank you for purchasing the Dome Z-Wave Water Main Shut-Off, which works with your Z-Wave Certified Controller to let you control your water main while on vacation, or have it automatically shut off in case of leaks or other emergencies. LED Indicator Motor Assembly Mounting Bracket WATER MAIN SHUT-OFF SolidWorks Student Edition. For Academic Use Only. 1. For proper inclusion, bring the Water Main Shut-Off to the final location where it will be used.
PAGE 2
6. Override Operation Position the bolt of the Water Main Shut-Off DIRECTLY above the bolt of the ball valve, and tighten the hose clamps until the Shut-Off is completely secure (fig 5.) Centers are aligned It is absolutely critical that the axes for both the valve and Water Main Shut-Off are aligned. Improper installation will result in unreliable performance. Examine Figure 5 for more details and please visit www.domeha.com/ support if you require further assistance. 7. 8.