User`s guide

Installing the Display | 7
Connect the Video and Power Cables
Leave your computer off. Make sure the power cord is plugged into
the grounded outlet. Use only the power adapter and video cables
shipped with the Dome EX display. ( For the Dome E2 display, use
power adapter Ault MW116KA1249F53. For the Dome E3 display,
use power adapter Ault MW122KA1223F52.)
To connect the cables
1 Starting with your first or only display, plug one end of
the DVI cable into the DVI port on the connector plate.
Secure the connection.
2 Plug the power cord into the power input port on the plate.
3 Plug the other end of the DVI cable into the main connector
(Video 1) port on the installed video card (the bottom port of the
MX2 or MX3 board). (See page 6.) Secure the connection.
4 Plug the other end of the power cord into the power adapter, and
plug the power adapter cord into a grounded AC outlet.
5 If setting up a second display, attach the DVI cable to the display
port and to the top port of the controller board. Then install the
power adapter unit.
Power input port (left)
Video port (right)
Dome EX display
connector plate