User`s guide

DIN Test Service | 81
Running a DIN Constancy Test
You must successfully run a DIN acceptance test (described in the
previous section) on the device being tested before you can run the
constancy test described below. If the Privilege service is installed,
you must log on as a privileged user before you run a DIN constancy
test. (See page 96.)
To run a DIN constancy test
1 Open the Dome CXtra Services menu and select DIN Test
2 Click Run Constancy Test to open the test selection dialog.
3 Select the constancy tests you want to run, and then click OK.
4 Using the photometer identified in the setup procedure, follow
the instructions provided by the test wizard.
NOTE: For photometers not identified by name on the setup pull-
down list, type the photometer reading into the fields provided in
the test wizard dialogs.