User`s guide

40 | Dome CXtra
Configuring the DICal Service
The desktop display ships with brightness and contrast values already
set as shown in the table below for DICOM compliance. Start at
procedure step 2 to configure the DICal service upon initial use. Use
the entire procedure to configure the service after display settings
have been changed.
To configure the DICal service
1 Set the brightness and contrast of your display to the values in
this table. (Refer to the display manual for how to set the values.)
2 Open the Dome CXtra Services menu and select DICal Panel
Configuration.
3 Verify that the model number of your display appears in
the dialog.
If the correct model number is visible, skip to step 5.
If the model number is incorrect, continue to step 4.
4 Click Edit Type, select the model number of the display from
the drop-down list, and click OK.
NOTE: Displays listed have been characterized; therefore, the
Characterize button is disabled. You cannot recharacterize a
display that has been characterized previously.
5 Open the Calibration tab and select DICOM response function.
6Click OK.
Display Model Brightness Contrast
Dome Q2 65% N/A
GX2MP (JUN 2007 or later) 75% 70%
GX2MP 75% 70%
Desktop PX191 70% 50%
Desktop PX1910M (2007 or later) 70% 60%
Desktop PX1910M 70% 50%
Desktop PX212M 80% 80%
Desktop PX212M (RoHS) 80% 50%