Tronic Mifare Instructions
Tronic Mifare INSTRUCTIONS MANAGEMENT CARD MASTER CARDS USER CARDS
Cards and functions MANAGEMENT CARD Function: Create and Delete Master Cards MASTER CARD Functions: Create / Delete User Cards (Single user only), Inspection mode and Delete User Cards USER CARD Functions: Open / Close locks SETTINGS CARD Transfer settings from software to locks Modes : Multiuser (Public) / Single User (Private) Acoustic signal Automatic opening time
Tronic Mifare INSTRUCTIONS Single user: Open and close SINGLE USER ■ The lock is closed. ■ Place the assigned User Card close to the lock. The lock will open. ■ After 2 seconds the latch closes automatically. OK: Green LED 1 long beep = the lock is closed NOT OK: Red LED and 3 short beeps. Create and delete User Cards (only for single user mode) CREATE: ■ Place the assigned Master Card close to the lock, followed by the new User Card. ■ Up to 50 User Cards can be created per lock.
Multiuser: Open and close MULTIUSER ■ The locker is open. ■ Place a blank User Card close to the lock. The lock is now assigned to the card. ■ If you present your card again the lock will open and reset for the next usage. (Same or different User card) OK: Green LED 1 long beep = the lock will close NOT OK: Red LED and 3 short beeps = lock is already assigned to another User Card or the User Card is already assigned to another locker.
Tronic Mifare INSTRUCTIONS Create and delete Master Cards CREATE: ■ Place the Management Card close to the lock, followed by the new Master Card. ■ Up to 5 Master Cards can be DELETE: ■ Green LED and long beep = Master Card created successfully. ■ Red LED and 3 short beeps = Master Card not created. created per lock. ■ Place the Management Card close to the lock, followed by the Master card. ■ Green LED 2 fast blinks and 2 short beeps = Master Card deleted.
Delete all User Cards x4 ■ Place the Master Card close to the lock (4 times) ■ All User Cards for this lock have now been deleted. Reset User Cards x5 ■ Place the Master Card close to the lock (5 times), followed by the User Card to be deleted. ■ 1 long beep = User Card deleted. ■ This card is now available for a new user.
Tronic Mifare INSTRUCTIONS Programmable settings (management software and cable required) AUTOMATIC OPENING TIME: ACOUSTIC SIGNAL VOLUME: CODES: The lock will open automatically ■ High/Low/Off ■ User / Master ■ hh : mm LED INDICATION LAST EVENTS ■ Mon, Tue, Wed, Thu, Fri, Sat, Sun OF CLOSED POSITION: BATTERY LEVEL ■ Working days ■ On/Off blinking red LED NUMBER OF OPERATIONS ■ Two options: when locker is closed at the programmed time: 1. Leave door open 2.
Table Reader/Writer Used to read or write information Use of the Table Reader allows remote from cards and bracelets. management functions (i.e. from In conjuntion with the software, a reception desk) such as: ■ Read last events of the locks. the Table Reader is an essential ■ Create and delete master/user cards ■ Read all settings from locks. accessory for complete management ■ Read relevant information from the ■ Create Settings Card to modify of RFID installations. card (locker Nr.
Tronic Mifare INSTRUCTIONS Batteries replacement 1. Connect the battery pack. 2 2. Loosen the Torx 20 screw. 3. Remove the battery holder. IMPORTANT: Battery replacement must completed in less than 5 minutes. The battery pack must remain connected during the release of 1 the batteries (otherwise, the clock will lose the programmed time).
Tronic Mifare WARRANTY AND WARNINGS Warranty and liability Our General Terms and Conditions apply. We do not accept liability ■ Failure to observe the notices in these instructions for personal injury or property ■ Incorrect assembly damage resulting from one or ■ Incorrect product repairs more of the following: ■ Disasters caused by external ■ Improper use of the furniture lock influences and force majeure.
