Specifications

4 Dolphin® 9500 Series Net Base Quick Start Guide
Configuring the Network
By default, the Net Base is configured to obtain IP addresses automatically via
DHCP server. This means that in most cases you would simply “plug and play”
the unit. If necessary, you can use the configuration utility for dynamic network
configuration.
If Your DNS Server Supports Bind 8.3 or Later
1. Obtain the serial number from the label on the bottom panel of the Net Base.
2. Connect to the network.
3. Power up and wait until the COMM LEDs stop flashing. The COMM LEDs
stop flashing when the Net Base has found the DHCP server.
4. On your PC, open the web browser and enter the Net Base serial number
exactly as it appears on the label.
5. Press ENTER and the online configuration utility displays on your PC.
If Your DNS Server Does Not Support Bind 8.3 or Later
If your DNS server does not support Bind version 8.3 or later, Hyperterminal™
or an equivalent terminal emulator program must be installed on the host PC to
configure the Net Base.
1. Connect the serial cable to the Serial DB-9 Connector on the back of the Net
Base and a COM port on the host computer.
2. Start Hyperterminal or an equivalent terminal emulator program. Use these
settings: 115200 bps, 8,N,1.
3. Power up and wait until the COMM LEDs have stopped flashing. The COMM
LEDs stop flashing when the Net Base has found the DHCP server.
Flashing
Orange
Data is being transferred between the terminal
and the Net Base.
Color Description