Specifications

Dolphin® 9500 Series Net Base Quick Start Guide 1
Dolphin 9500 Series Net Base
Quick Start Guide
Introduction
The Dolphin Net Base charges up to four Dolphin 9500 Series mobile computers
and enables each one to communicate with a host device over an Ethernet
network.
Unpacking the Net Base
Use only Dolphin 9500 Series peripherals, power cables, and power
adapters. Use of peripherals, cables, or power adapters not sold/
manufactured by Hand Held Products will void the warranty and may
damage the terminal.
Open the shipping box and inspect the package to see that the following
standard items are included:
• One Dolphin Net Base Ethernet cradle
• One Universal AC-DC Power Adapter for the Dolphin Net Base
• One Power Cord
• One Serial Extension Cable
• Two Mounting Brackets (available separately)
These are the items you need to set up, configure, and operate the Dolphin 9500
Series Net Base. If any items are missing or anything appears to be damaged,
contact your Customer Account Representative.
Keep the original packaging in case you need to return the Net Base for service
or store the Net Base while not in use.
Software Requirements
Any Dolphin 9500 Series terminal interfacing with the Net Base should have the
following software installed:
• Kernel 7.03, Service Pack 3 or higher and
• Utils, version 2.4 (Utils_24.cab) or higher
To confirm which software is loaded on your terminal, go to Start > Utils >
SysInfo. A document appears listing the software loaded on your terminal; the
kernel and service pack appear at the top of the list.
!