Dolphin PROX2 GYRO Pool Cleaner Operating Instructions by 8151615
Dolphin PROX 2 Gyro Robotic Pool Cleaner Operating Instructions Contents 1. INTRODUCTION..............................................................................3 2. SPECIFICATIONS.............................................................................3 3. WARNINGS AND CAUTIONS.........................................................3 3.1. Warnings.................................................................................3 3.2. Cautions.......................................................
Dolphin PROX 2 Gyro Pool Cleaner Operating Instructions 1. INTRODUCTION Thank you for purchasing a Maytronics Robotic Pool Cleaner. We are sure that your Maytronics Robotic Pool Cleaner will provide you with reliable, convenient and cost effective pool cleaning. Its reliable filtration in all pool conditions and all-surface climbing brush enhance maximum pool hygiene. The Robotic Pool Cleaners by Maytronics deliver advanced cleaning technologys, long lasting performance and easy maintenance. 2.
4. POOL CLEANER PARTS Dolphin PROX 2 Gyro Caddy Combined Brush For rough ceramics. Surface and mosiac tiles. Wonder Brush For smooth ceramics.
5. USING THE POOL CLEANER 5.1. Set Up 40°C Max 104°F Max GFI/ELI A A Change diagonal handle position for water line sideway movement. To adjust the handle angle: A. Press the latch down and hold it in position. B. Move the handle to the desired position and release the latch to hold the handle in place.
5.2. Putting the Pool Cleaner into the pool I f Wonder brush/ Wonder rings are dry, soak them in water until soft. ON Turn the power supply ON 5.3. Removing the Pool Cleaner from the pool OFF The robot will perform automatic shut-off at the end of the cleaning cycle.
Using the floating cable, bring the Pool Cleaner to the pool’s edge. CAUTION Do not pull the Pool cleaner from the pool using the cable 5.4. Maintenance lean the filter bag with a hose. C Periodically clean the brushes with a hose. It is recommended to periodically wash the filter bag in a washing machine. Use gentle cycle program.
Cleaning the impeller Unplug the power supply If you notice debris trapped in the impeller open the impeller and remove the debris. Cable To remove the kinks, stretch the cable out completely and let it sit for at least a day in the sun. 5.5. Off season storage If the pool cleaner will not be in use for an extended period, perform the following storage steps: • Make sure that no water is left in the pool cleaner. • Thoroughly clean the filter bag and insert in place.
6. POWER SUPPLY Digital “Switch-Mode” Power Supply with full filter bag and delay indicator. • Input - 100-250 AC Volts • 50-60 Hertz • 180 Watt • Output - <30 VDC • IP 54 <30 VDC; IP 54 Delay indicator Full filter bag indicator <30 VDC; IP 54 On/Off switch Reset button Full filter bag indicator and Reset button The power supply is equipped with a filter bag status indicator. The red LED indicates two filter conditions. • When blinking - The filter is partially blocked.
7. REMOTE CONTROL UNIT The Control Panel Radio reception meter When no black lines are showing, move closer to the power supply unit Battery level meter When flashing, change the batteries Manual control indicator When flashing, you are in manual direction control mode Cleaning cycle icons Delay timer icons Cleaning mode icons ON/OFF button Manual/automatic select button Set/OK button Direction control arrows Manual Direction Control Mode 1. Press the On/off button once.
Press the manual/automatic select button and then choose the desired parameters according to the following table: Cleaning cycle indicator This determines the length of the cleaning cycle. Fast 4-hour cycle Efficient 6-hour cycle for everyday use. (Default setting) Extra 8-hour cycle Delay time indicator This determines when the pool cleaner starts to work. Delaying allows the dirt to settle to the bottom of the pool.
Dolphin PROX2 GYRO Pool Cleaner by 8151615
