Installation Guide

DOLLE USA

1200 Mendelssohn Ave. No., Suite 140

Minneapolis, MN 55427

763-746-7830 763-746-7835 fax

5. Hand Rails

Beech hand rails (finished PA3a or raw PA3) can be installed

on your posts or on your wall (PA9 Wall fitting, sold separately). Beech handrails are for

indoor use only. Remove the plate from the post top bracket to screw handrail to post.

Note: Pilot holes required. Connect railings together in a straight line with Handrail

Connections (PA8, sold separately), or at any angle from 0- 90° with Handrail Junctions

(PA6, sold separately). Use Handrail Endcaps (PA7, sold separately), to finish your

handrail run.

Aluminum handrails (PA4) can be installed on your posts, or on

your wall (PA9 Wall fitting, sold separately). Loosen the plate from the post top bracket

to slide handrail onto post, then tighten set screws securely. Connect railings together in a

straight line with Handrail Connections (PA8, sold separately), or at any angle from 0-

90° with Handrail Junctions (PA6, sold separately). Use Handrail Endcaps (PA7, sold

separately), to finish your handrail run. For best finished results, if cutting handrails is

necessary, it is recommended that you have your aluminum handrails professionally cut.

Handrail endcaps (PA7) are installed to finish your run of wood

or aluminum handrails. Using an allen wrench (not supplied), remove the plug from the

end cap. Drill pilot hole (in wood handrails) or use existing hole (in aluminum handrail),

and mount plug onto handrail with screw provided. Then replace the cap, and tighten set

screw securely. For wood handrails, it is recommended that you use a drilling template

(PA21, sold separately) to drill 1/8” pilot holes on center.