Installation Guide

DOLLE USA

1200 Mendelssohn Ave. No., Suite 140

Minneapolis, MN 55427

763-746-7830 763-746-7835 fax

Handrail Junction (PA6) can be installed on wood or aluminum

handrails for any angle from 0- 90°, or going around corners. For wood handrails, it is

recommended that you use a drilling template (PA21, sold separately) to drill 1/8” pilot

holes on center. Using an allen wrench (not supplied), remove the plugs from handrail

connection. Drill pilot holes (in wood handrails) or use existing holes (in aluminum

handrails), and mount plugs onto handrails with screws provided. Reinstall plugs on

handrails into ends of connector and tighten set screws securely. Once you have your

angle established and set, tighten set screw on connector securely.

Handrail connection/ wall terminal (PA8) can be installed on

wood or aluminum handrails to either join handrail to handrail in a straight line, or attach

handrail to wall. For wood handrails, it is recommended that you use a drilling template

(PA21, sold separately) to drill 1/8” pilot holes on center. Using an allen wrench (not

supplied), remove the plug from handrail connection. Drill pilot holes (in wood handrails)

or use existing holes (in aluminum handrails), and mount plug onto handrail with screw

provided. Repeat this process with the body ½ of the connector. Reinstall plug on

handrail into end of connector and tighten set screw securely. While securing handrail

connector with backing material in place is strongly recommended, if adequate backing

material is not in place, a toggle bolt or heavy duty sheetrock anchor can be used. (Sold

separately).