Installation Guide

DOLLE USA
1200 Mendelssohn Ave. No., Suite 140
Minneapolis, MN 55427
763-746-7830 763-746-7835 fax
4
Stainless Steel Tubes (PA5) are installed through the fittings
provided on your posts. Loosen set screw on each fitting to slide your tubes through, then
tighten each set screw securely. For seamless tube to tube connections, splice them at the
post fittings. Use the plastic caps provided to finish tube ends. It is recommended that an
angle grinder be used to cut tubes.
Steel tube connector/ elbows (PA10) are installed into the ends of the steel tube in fill.
They can be used in straight runs or for going around corners. Using a small amount of
construction adhesive, insert connector into end of tube and turn a full circle to spread
adhesive around inside of tube. Once you have your angle established and set, tighten set
screw securely. Allow 24 hours for adhesive to dry. Remember to wipe off excessive
adhesive right away.
Wall terminals for tube filling (PA11) connect your steel tubes
individually to a perpendicular wall. Line up your tubes against the wall to mark
connection points. Use the screws provided to secure fittings to wall. While securing
handrail connector with backing material in place is strongly recommended, if adequate
backing material is not in place, a toggle bolt or heavy duty drywall anchor can be used.
(Sold separately). Then slide tubes into fittings and tighten set screws securely.