Battery Charger TC200i Owner’s Manual
Introduction The TC200i Battery Charger is electrically compatible with all 7.2V/14.4V Li-Ion camera batteries rated 900mAh or higher. The modular design allows for different battery models to be charged and tested when the appropriate adapter plate is fitted. Because the charger is software controlled, its functionality allows for flexibility in charging and testing of batteries used. In addition to charging, battery testing option is available.
90%) in about 2.5 hours. A 5600 mAh pack will take approximately 3.5 - 4 hours to charge. Since a depleted battery pack absorbs charge current faster, than a partially charged one, most of the charge energy is absorbed during the initial stage of charging and then the rate of charge levels off towards the end. Charge channels Both charge channels are fully independent from each other; charge initiation and termination depend on a battery’s state of charge.
A letter “t” will be displayed while channel 1 status information is shown The charger will fully charge the battery, fully discharge using its internal load (LCD will display “Discharging”), and then fully charge for complete readiness. The amount of charge delivered to the load is displayed on the LCD panel. This is the true battery charge capacity in mAh. Dolgin Engineering 1019 Massachusetts Ave. Lexington, MA 02420 • (781) 863-1813 • www.dolgin.
