Manual

Figure 8: Target device list
a) If you select Dolby Atmos, to specify the number of overhead speakers, open the
Settings menu.
b) Select Speaker Configuration.
c) From the Dolby Atmos Speaker Configuration drop-down list, select a desired
configuration.
You can monitor the presentation in the intended target device configuration (stereo, 5.1,
and so on) through the MADI output using the monitoring mode selection.
4.9 Monitoring loudness value
You can monitor loudness value according to one of two loudness standards as described in
these recommendations: ITU-R BS.1770-3 (with or without using an automatic DI) and EBU
R128.
About this task
This procedure allows you to monitor the loudness value using the client application.
However, the front-panel display also shows this value.
Procedure
1. From the View menu, select Loudness Measurement.
The Loudness Measurement window appears and displays loudness value.
2. Optional: From the drop-down list, you can select a different loudness recommendation
measurement method.
4.10 Monitoring 5.1-channel downmix
You can monitor a stereo downmix of a 5.1 channel configuration on the local output.
About this task
These settings are not applied to the presentation metadata and are intended only to
simulate the end device output.
Procedure
1. To enable the 5.1-channel downmix monitoring, in the main window, click on the STB
Mode button.
Dolby Object Authoring Tool DP590 operation
Dolby Object Authoring Tool DP590 quick-start guide
Preliminary 10 May 2017 24