Manual
Table Of Contents
- Contents
- 1 Introduction to Dolby Object Authoring Tool DP590 documentation
- 2 Overview of Dolby Object Authoring Tool DP590
- 3 Installation of Dolby Object Authoring Tool DP590
- 4 Dolby Object Authoring Tool DP590 operation
- 4.1 Creating new or opening existing session
- 4.2 Saving session
- 4.3 Adding beds and dynamic objects
- 4.4 Modifying input channel routing
- 4.5 Enabling beds and dynamic objects for presentations
- 4.6 Setting production renderers
- 4.7 GPIO configuration
- 4.8 Monitoring local output
- 4.9 Monitoring loudness value
- 4.10 Monitoring 5.1-channel downmix
- 4.11 Monitoring dynamic range control
- 4.12 Monitoring audio meters
- 4.13 Connecting to DP591
- 4.14 Sending metadata to DP591
- 5 Error log
- Glossary
3.2.1 Configuring command port
The DP590 uses a COMMAND port network connection.
Procedure
1. In the front panel-navigation key set, press the escape key.
The DP590 menu is displayed.
2. Go to DP590 Settings > System Settings > IP Settings > Command Interface.
3. Select Static IP Mode or DHCP Mode, depending on the network:
•
For Static IP Mode, configure the IP address, mask (MSK), and gateway (GWY), then
select Apply.
Note: Do not use the 192.168.1.2 IP address. It is used internally by the DP590.
•
For DHCP Mode, select Apply.
3.2.2 Checking IP address
Check the IP address of your DP590 to be able to connect through your web browser or to
the DP590 software client.
About this task
You can check the IP address in the DP590 user-control screen.
Procedure
1. In the front-panel navigation key set, press the escape key.
The DP590 menu is displayed.
2. Use the left or right arrow key to navigate to the CMD Interface screen.
The CMD Interface screen displays the IP, mask (displayed as MSK) and gateway (GWY)
information.
3.3 Downloading and installing DP590 client
Install the DP590 client to control the unit functions.
Prerequisites
To install the DP590 client software, the operating system must be Microsoft Windows 7 or
later.
You must install the Microsoft Visual C++ 2010 Redistributable Package prior to installing the
DP590 client application. Use these links to download the package:
•
For the 32-bit version: https://www.microsoft.com/en-us/download/details.aspx?id=5555
•
For the 64-bit version: https://www.microsoft.com/en-us/download/details.aspx?
id=14632
Installation of Dolby Object Authoring Tool DP590
Dolby Object Authoring Tool DP590 quick-start guide
Preliminary 10 May 2017 13