Installation manual

UEX/650 Upgrade Kit Installation
11
Setup Menu
123 7456 8
DIP switch 6 UP
The Bsl and Bsr channels shown in italics are available only with Cat. No. 794 installed.
B-Chain:
menu
OK
menu
OK
Notes
Format and CP650 status
display
0–10
Adjust fader. Standard
setting is 7.0.
1
Calibrate SPL 45–108.5 dB
Calibrates CP650 internal
SPL meter to agree with
auditorium sound level
meter reading.
2
Output Levels Adjust (initial)
Channel:
Level:
L, C, R, Ls, Bsl, Bsr,Rs
1–127 (0.3 dB steps)
Subwoofer level is set in
separate menu items.
3
Digital Subwoofer Level
Adjust (initial)
Level: 1–127 (0.3 dB steps)
4
Bulk EQ Adjust
Channel:
Bass Adjust:
Treble Adjust:
Corner Frequency:
L, C, R, Ls, Bsl, Bsr, Rs
± 6 dB
± 10 dB
1, 2, 3, 4 kHz
Set these before adjusting
B-Chain EQ.
(Fixed at 2 kHz for Ls, Bsl, Bsr,Rs)
Select channel:
L, C, R, Ls, Bsl, Bsr, Rs
OK
Press OK to start.
Select frequency band:
40 Hz–16 kHz
5
B-Chain EQ Adjust
menu
OK
+ =
Hold down middle button and turn the knob to adjust
level: ± 6 dB in the selected band.
OK
TO EXIT: Press OK to
save, then press the Left
button to move back to the
channel selection menu.
6
Subwoofer EQ Adjust
EQ center frequency:
EQ filter width (“Q”):
Level Cut:
25–125 Hz
0.5, 1, 2, 4
0 to –12 dB
7
Output Levels Adjust (final)
Channel:
Level:
L, C, R, Ls, Bsl, Bsr, Rs
1–127 (0.3 dB steps)
Final level adjustment
after EQ.
8
Digital Subwoofer Level
Adjust (final)
Level: 1–127 (0.3 dB steps)
9
Optical Subwoofer Bandwidth 50 Hz / 100 Hz 50 Hz / 100 Hz
Match SW to LF limit of
main screen speakers.
10
Optical Subwoofer Level
Level:
Polarity:
Center Noise:
1–127 (0.3 dB steps)
Normal / Inverse
on / off
Perform final level
adjustment and polarity
check: center noise LF
output should decrease
when polarity is inverse.
System Software v1.1xx