Operating instructions
RQTX0165
35
Error messages
Display Check point/Cause/Countermeasure Pages
Set the same remote control code for this system and remote control.
If “REMOTE 2” is displayed, set remote control code to “2”.
If “REMOTE 1” is displayed, set remote control code to “1”.
•
34
The equipment connected by the HDMI cable is not compatible with this
system’s copyright protection technology.
•
—
The system is receiving video signals that are incompatible with it through
HDMI connection. Check the settings of the connected equipment.
•
—
A problem has occurred with the HDMI connection. Try the following to correct
the problem. Consult your dealer if the error code remains on the display.
―
Turn the connected equipment off and on again.
―
Disconnect the HDMI cable then reconnect it.
―
Do not connect more than 2 equipment in series to the output of this system.
•
—
—
—
(Scrolling)
You cannot use Dolby Virtual Speaker, Dolby Pro Logic
and SFC for dual
sounds.
•
32
(Scrolling)
You cannot use Dolby Virtual Speaker, Dolby Pro Logic
and SFC effect with
PCM signals with sampling frequency over 48 kHz.
SFC is not available for multi-channel LPCM signal.
•
•
26
26
AMPLIFIER SECTION
RMS Output Power of each channel driven
10 % total harmonic distortion
1 kHz Front CH 70 W per channel (4
Ω)
1 kHz Center CH 70 W per channel (4
Ω)
100 Hz Subwoofer CH 90 W per channel (3
Ω)
Total RMS Output Power 300 W
Rated minimum sine wave RMS power output
1 % total harmonic distortion (Dolby Digital Mode)
120 Hz - 20 kHz Front CH 45 W per channel (4
Ω)
120 Hz - 20 kHz Center CH 43 W per channel (4
Ω)
45 Hz - 120 Hz Subwoofer CH 57 W per channel (3
Ω)
Total FTC Output Power 190 W
Rated minimum sine wave RMS power output
1 % total harmonic distortion (Stereo mode)
120 Hz - 20 kHz Front CH 47 W per channel (4
Ω)
45 Hz - 120 Hz Subwoofer CH 57 W per channel (3
Ω)
Total FTC Output Power 151 W
Total harmonic distortion
half power at 1 kHz (Front CH) 0.5 % (4
Ω)
Input sensitivity
TV, AUX 3 450 mV, IHF’66
S/N at rated power
BD/DVD, TV, AUX 1, AUX 2 80 dB
Input impedance
TV, AUX 3 47 k
Ω
Tone controls
BASS 50 Hz, +6 dB to -6 dB
TREBLE 20 kHz, +6 dB to -6 dB
Digital input/output
HDMI Input 1
HDMI Output 1
Optical digital input 2
Coaxial digital input 1
This system supports “HDAVI Control 3” function.
Analog input/output
Analog audio input 2
OPERATING CONDITIONS:
Operating temperature range:
0°C to +40°C
(
+32°F to +104°F
)
Operating humidity range: 20% to 80% RH (no condensation)
Specifications
GENERAL
Power supply AC 120 V, 60 Hz
Power consumption
Main set 68 W
Standby (HDMI ON) 0.7 W
Standby (HDMI OFF) 0.3 W
SPEAKER SYSTEM
FRONT (L/R) 1-Way 1 Speaker System (Bass Reflect)
6.5 cm (2
1
/
2
”
) Cone Type Full Range x1
Input power (IEC) 70 W (Max/4
Ω
)
Output sound pressure level 79 dB/W (1.0 m)
Frequency range 80 Hz - 25 kHz (-16 dB)
95 Hz - 22 kHz (-10 dB)
CENTER 1-Way 1 Speaker System (Bass Reflect)
6.5 cm (2
1
/
2
”
) Cone Type Full Range x1
Input power (IEC) 70 W (Max/4
Ω
)
Output sound pressure level 79 dB/W (1.0 m)
Frequency range 80 Hz - 25 kHz (-16 dB)
95 Hz - 22 kHz (-10 dB)
SUBWOOFER 1-Way 2 Speaker System (Bass Reflect)
13 cm (5
1
/
8
”
) Cone Type Woofer x2
Input power (IEC) 90 W (Max/3
Ω
)
Output sound pressure level 82 dB/W (1.0 m)
Frequency range 35 Hz - 600 Hz (-16 dB)
42 Hz - 500 Hz (-10 dB)
RACK SYSTEM
(INCLUDING SPEAKER)
Dimensions (W x H x D) 1300 mm x 444 mm x 458 mm
(51
1
/
8
” x 17
15
/
32
” x 18
1
/
32
”)
Mass approx. 50k
g
(110.2 Ibs)
Mass is a Completed (AMP, Speaker Unit inc)
Maximum Loading Weight 80 k
g
(176.4 Ibs)
Rating with low-cut filter equipped amplifier
Note
1. Specifications are subject to change without notice.
2. Total harmonic distortion is measured by the digital spectrum
analyser.
Reference
Error messages/Specifications
SC-HTR310 (RQTX0165-P) - 14.07.08.indd 35 7/16/2008 1:52:25 PM