User`s manual

B-Chain Alignment Procedures
Notes
5-5
5.2 Setting Room Equalization
Set the FADER to the 0 position.
Verify that the fader local active LED is on. If necessary, press the FADER
ACTIVE switch.
Set the NORMAL/BYPASS switch to the NORMAL position.
Simultaneously press and hold the 04 and 05 switches until the mic LED
lights (approximately 7 seconds). When the 04 and 05 switches are released,
the mic's LED will flash and internally generated pink noise will
automatically cycle L,C,R,S,L…etc.
Press the 05 switch when the signal present LED on the front panel for center
is illuminated. This will suspend the cycling.
Note: Pressing the 04 switch will cause the cycling to resume. Pressing the
mic button will turn off the pink noise.
Slowly advance the FADER control to position 7. You should hear pink noise.