Technical information

2. Select the format you want your video output to be. You may select DVD+VR, DVD-

Video, or VCD file output from the Disc Format drop-down menu.

NOTE: You can also make your file format selection from within the CREATE

module. This allows you to see the estimated disc size.

NOTE: Using the DVD+VR format allows you to modify the disc contents at a later

time. You can record over information stored on a +VR formatted recordable DVD

disc as you would a VHS tape.

3. Select which video format (PAL or NTSC) you want your final DVD or VCD files to

be viewed in. Select where your video will be viewed in the Viewable In drop-down

box. neoDVDplus automatically converts it to the appropriate format. neoDVDplus

allows you to create a PAL DVD/VCD from an NTSC source file and vice versa (i.e.,

direct PAL/NTSC conversion).

4. Select a target drive in which to create your DVD or VCD. Click on the Write To

drop-down box. The available drives (CD or DVD-Recordable drive, or Hard Disk

Drive) on your PC are listed.

NOTE: If you want to write your DVD project to your Hard Disk Drive, you need to

create a new folder for each project. The default folder name for all DVD projects is

VIDEO_TS. Therefore, if you do not create a new folder to save your DVD project,

each DVD project you save overwrites the previous one. The Folder option allows

you to select the folder to file your DVD.

5. If you are writing to a recordable drive, you can create your own disc label by

entering your desired text in the Disc Label box.

6. Select a write speed that is appropriate to your CD or DVD-recordable drive. By

default, your CD or DVD-recordable drive is set to the MAX write speed. If the write

speed of the media (disc) is lower than the write speed of the recordable drive,

select the lower write speed from the Speed drop-down menu.