Specifications

Configuring the System Parameters
Dolby
®
Professional Reference Monitor Manual 25
2. Usetheup/downarrowkeys,andpress
ENTER toactivatethedesiredslider,thenuse
theleft/rightarrowkeystochangeasetting,andpress
ENTER againtosave.
•Asingleright‐arrowkeypressincreasesthecurrentvalueby0.0001.
•Asingleleft‐arrowkeypressdecreasesthecurrentvalueby0.0001.
•Pressingandholdingtherightarrowformorethan1.5secondsincreasesvalues
continuouslyby0.001.Themaximumvalueis0.5.
•Pressingandholdingtheleftarrowformorethan1.5secondsde
creasesvalues
continuouslyby0.001.Theminimumvalueis0.2.
2.4.3 Configuring the Gamma
Toconfigurethisparameter:
1. Pressthe
SYSTEMkeytoactivatethetabmenu,thenusethearrowkeys(orthe
SYSTEM key)tomovetotheGamma/LUTs tab.
The
Gammascreenappears,withPure GammaandCustom LUTparameters,asshown
inFigure 2‐30.
Figure2‐30 
Figure 2-30 System/Gamma Screen
Inthisscreen,youcanusethearrowkeystospecifya puregammaora1DcustomLUT
gammathatwasloadedfromaUSBstoragedevice.(SeeLoadinga1DLUTon
page 39.)Pressthe
ENTERkeytosave.
Ifyouselect
Custom,adialogboxappears,whereyoucanspecifythedesiredgamma,
asshowninFigure 2‐31.
Figure2‐31 
Figure 2-31 System/Gamma/Custom Gamma Screen
Note: TheGamma/LUTs tabisinaccessiblewhentheinputisLu’v’, orwhenanemulation
modeisactive.Insuchcases,thegammaisabsolute.(DolbyLu’v’isanewvideo
formatdevelopedbyDolbyLaboratoriesforpotentialfuturevideoapplications.)