Specifications

Installing the PRM-4200
Dolby
®
Professional Reference Monitor Manual 7
4. ConnectthePRM‐4200powercabletoanACpowersource,thenpressthepower
switchtoturnonthemonitor,asshowninFigure 2‐4.
Figure2‐4 
Figure 2-4 Connect AC Power and Turn On Monitor
WhiletheRemoteisbooting,theDolbylogoappearsonitsuserdisplay,andthena
messageindicatesthatitissearchingforaconnectedmonitor,asshowninFigure 2‐5.
Figure2‐5 
Figure 2-5 Searching for Monitor Screen
WhentheRemoterecognizesthePRM‐4200,theDolbylogoappears,andthenthe CRT
Reference Mode Status 1
screenappears,asshowninFigure 2‐6foranHD‐SDI3G
LevelAinput.
Figure2‐6 
Figure 2-6 CRT Reference Mode Status 1 Screen (HD-SDI Input Source)
CRTReferencemodeisthedefaultPRM‐4200operatingmode.Theotheroperatingmodes
(DynamicReference,LCD,PDP,Custom1,Custom2)displaysimilarinformationintheir
respectivestatusscreens.Tabmenusprovideaccesstotheappropriateparametersand
otherinformationasyoumovefromscreentoscreen.Alloftheoperat
ingmodesandtheir
correspondingparametersaredescribedindetaillaterinthischapter.Section 2.2shows
youhowtousetheRemotetooperatethePRM‐4200.
Connect AC power
Press power
switch
SMPTE timecode
Tab menu
Current operating mode
Output statusInput status
Press right arrow on Remote to highlight tab and display timecode-only screen