Technical data

2-2 Important directions for use MKE UL/CSA
DOK-MOTOR*-MKE*UL/CSA*-PR01-EN-P
Areas of use and application
MKE AC synchronous motors are designed to execute application-
specific axle movements in explosion-endangered areas together with
drive control devices of lines DIAX04 and ECODRIVE.
Typical areas where MKE motors can be applied are:
· enameling systems,
· chemical industry
Available for an application-specific use of the motors are unit types with
differing drive power and different interfaces.
Control and monitoring of the motors may require additional sensors and
actors.
Note: The motors may only be used with the accessories and parts
specified in this document. If a component has not been
specifically named, then it may not be either mounted or
connected. The same applies to cables and lines.
Operation is only permitted in the specified configurations and
combinations of components using the software and firmware
as specified in the relevant function descriptions.
Every drive controller has to be programmed before starting it up, making
it possible for the motor to execute the specific functions of an application.
The motors may only be operated under the assembly, installation and
ambient conditions as described here (temperature, protection categories,
humidity, EMC requirements, Ex class, etc.) and in the position specified.
2.2 Inappropriate use
Using the motors outside of the above-referenced areas of application or
under operating conditions other than described in the document and the
technical data specified is defined as “inappropriate use".
MKEs may not be used if
· they are subject to operating conditions that do not meet the above
specified ambient conditions. This includes, for example, operation
under water, in the case of extreme temperature fluctuations or
extremely high maximum temperatures or if
· Rexroth Indramat has not specifically released them for that intended
purpose. Please note the specifications outlined in the general Safety
Instructions!