Technical data

MKE UL/CSA Commissioning, Operation and Maintenance 15-5
DOK-MOTOR*-MKE*UL/CSA*-PR01-EN-P
1. Unscrew the housing screws (1) with the allen key, size 2.5, 3 or 4.
2. Remove the lid of the motor feedback.
3. Remove the plug of the battery (2).
4. Unscrew the screws (3) of the battery’s clamping device (4) and
remove the battery.
6. Insert the ready-made battery corresponding to the motor type (part
No. 277133 or 281394) and reattach the clamping device (3) with the
screws (4) (max. torque 1.0 Nm).
Note: Do not pinch the battery cable!
7. Attach the plug of the battery (2).
8. Close the lid of the motor feedback.
9. Tighten the housing screws (1) using a torque wrench: 3.1 Nm for
MKE037, 1.3 Nm for MKE047 or 6.1 Nm for MKE098.
(1): Housing screws
(2): Battery plug
(3): Battery attachment screws
(4): Battery
Fig. 15-3: Battery exchange
10. Switch the power supply of the drive control device back on.
11. Carry out a test run of the axles.
Battery removal
Battery installation
Switching system back on