Technical data

Rexroth IndraDyn T Appendix for Motor Size 210R 14-3
DOK-MOTOR*-MBT********-PR03-EN-P
14.3 Installation
Mechanical Installation
When installing the motor, heed the general notes regarding safety in
chapter 3 “Notes Regarding Safety” as well as the special notes regarding
safety for installation in chapter 12 “Installation“.
The following mounting instructions describe a nonbinding, schematic
construction without considering the constructive specialty of the
machine; they serve only for general orientation.
The machine manufacturer must take into account the special
characteristics of his construction and must work out a binding assembly
plan.
Preparation
Initial state: The motor lies flat on a clean, level base.
1. Check whether the components are damaged. Defective components
may not be mounted.
2. Hold tools, auxiliary material, measuring and test equipment ready
and make sure that assembly can be carried out in a clean, dry and
dust-free environment.
3. Check all components and mounting areas, holes and threads, as
well as the O-ring nuts on the stator, whether they are clean and free
of burrs. Everything must be clean, stainless and completely free
of burrs. Clean and debur such areas if necessary.
4. Grease the O-rings with an ordinary lubricant grease and mount the
O-rings in the stator grooves. Avoid twisting and soiling of the O-rings.
5. Screw the ring screws required for transport into the opposite threads.
Check the machine construction whether longer ring screws with a
spacer sleeve are required.
Attend to cleanliness during all working steps!
When inserting the rotor into the stator, pay attention to the radial and
axial forces resulting from the magnetic force (see Fig. 11-3).
Safety