Technical data

Rexroth IndraDyn T Installation 11-7
DOK-MOTOR*-MBT********-PR03-EN-P
4
5
Mounting2.EPS
(4): Fastening screws for stator flange - machine housing
(5): Fastening screws for stator flange - stator
Fig. 11-8: Assembly of the stator flange
3. Screw the bearing ring onto the rotor flange using a torque wrench
and the screws (7).
4. Lower the rotor flange, with the attached bearing, into the rotor until
the centering unit (8) takes hold of the rotor flange in the rotor hole.
5. Loosen the fastening screws of the mounting ring on the stator (not
on the rotor), but do not remove them.
6
5
8
7
Mounting3.EPS
(5): Bearing ring fastening holes
(6): Rotor flange fastening screws
(7): Rotor - bearing ring fastening screws
(8): Centering unit
Fig. 11-9: Attaching the rotor flange to the bearing
6. Lower the rotor flange, with the attached bearing, over the rotor down
to the final position so that it is centered. Screw the rotor flange onto
the rotor using a torque wrench and the screws (6).
7. Screw the bearing ring onto the stator flange using a torque wrench
and the screws (5).
8. Loosen all the fastening screws on the mounting ring (9) and remove
the mounting ring.