Technical data

11-6 Installation Rexroth IndraDyn T
DOK-MOTOR*-MBT********-PR03-EN-P
9. Screw the stator flange onto the machine housing using a torque
wrench and the screws (6).
10. Check the accuracy and stability of all mounted parts and mechanical
connections.
After proper mechanical assembly, continue with the other connections.
Assembly with Mounting Ring (Optional)
The following figure shows the general mounting procedure. Note the
special mounting instructions of the machine manufacturer. All the
screwed connections shown below must be secured using Loctite 243.
Mount the motor according to the following schematic procedure.
1. Guide the machine housing over the stator-rotor package up to its
final position so that it is centered. Ensure that the stator centering
unit guides the motor sufficiently and that it aligns properly.
1
2
3
Mounting1.EPS
(1): Rotor
(2): Stator
(3): Mounting ring
Fig. 11-7: Assembling the stator-rotor package
2. Attach the stator flange and screw it onto the stator and the machine
housing using a torque wrench and the screws (4) and (5).