Technical data

11-4 Installation Rexroth IndraDyn T

DOK-MOTOR*-MBT********-PR03-EN-P

Assembly without Mounting Ring

The following figures show the general mounting procedure. Note the

special mounting instructions of the machine manufacturer. All the

screwed connections shown below must be secured using Loctite 243.

Initial state: The rotor and stator lie on a clean, level surface. All

previously described steps have been carried out.

Mount the motor according to the following schematic procedure.

1. Screw the stator flange (2) onto the stator (3) using a torque wrench

and the screws (5).

2. With a suitable tool (1), guide the stator into the machine housing (4)

so that it is centered and then push the stator into its final position so

that it is aligned properly.

Mounting5.EPS

(1): Lifting gear (2): Stator flange

(3): Stator (4): Machine housing

(5): Fastening screws for stator flange

(6): Fastening screws for stator flange - machine housing

Fig. 11-4: IndraDyn T stator installation

3. Screw the stator flange onto the machine frame using a torque

wrench and the screws (6).

4. Screw the rotor flange (7) onto the rotor (10) using a torque wrench

and the screws (9).

5. Attach the bearing (8) to the rotor flange.

6. Secure the machine housing with the stator against lifting from the

surface.

7. Guide the rotor package into the stator up to its final position so that it

is centered.