Technical data

11-2 Installation Rexroth IndraDyn T
DOK-MOTOR*-MBT********-PR03-EN-P
11.3 Mechanical Installation
WARNING
The rotor is magnetic! Risk of injury and
crimping danger by magnetic forces!
⇒ Eliminate movable metal objects or secure against
movement.
⇒ Carefully handle magnetic parts.
⇒ Wear protective clothing and use mounting tools.
The following mounting instructions describe a nonbinding, schematic
construction without considering the constructive specialty of the
machine; they serve only for general orientation.
The machine manufacturer must take into account the special character
of his construction and must work out special mounting instructions. Only
the assembly instructions of the machine manufacturer are binding.
Note: During assembly, avoid pinching or sticking of the stator and
damage to the motor-side centering unit or to the system-side
insertion fitting.
Avoid strain, pinching or other damage to the cable.
All screwed connections must be secured using LOCTITE 243
screw fastener. LOCTITE 243 – without an activator and at
room temperature – becomes hand-tight within about 15-30
minutes. The final strength is reached after about 12 hours.
Note: The description of the motors with sizes 210R, 530G and 530L
is provided in the Appendix (see Chapter 15).
Preparation
Initial state: The motor lies flat on a clean, level base.
1. Check whether the components are damaged. Defective components
may not be mounted.
2. Hold tools, auxiliary material, measuring and test equipment ready
and make sure that assembly can be carried out in a clean, dry and
dust-free environment.
3. Check all components and mounting areas, holes and threads, as
well as the O-ring nuts on the stator, whether they are clean and free
of burrs. Everything must be clean, stainless and completely free
of burrs. Clean and debur such areas if necessary.
4. Before assembly, clean the contact surface of the stators with design
“..-ST-...” using a suitable cleanser (e.g. RIVOLTA A.C.S.3).
5. Grease the O-rings with an ordinary lubricant grease and mount the
O-rings in the stator grooves. Avoid twisting and soiling of the O-rings.
6. Screw the ring screws required for transport into the opposite threads.
Check the machine construction whether longer ring screws with a
spacer sleeve are required.
Attend to cleanliness during all working steps!