Technical data

18-6 Assembly MHD Sychronous motors

version 0.1 DOK-MOTOR*-MHD********-PR05-EN-P

If the cable output direction of the power connector of the MHD093 –

MHD131 motors were not considered when ordering them and now fails

to be the direction desired, it can be turned.

To achieve this, proceed as follows:

1. Loosen the two locking screws (4) and remove the cover of the flange

socket (2).

2. Loosen the four locking screws (3).

3. Now turn the flange socket housing (1) into appropriate position (by

steps in 90°).

4. Ensure that cable strands are prevented from being damaged or

tensioned unnecessarily.

5. Retighten the four locking screws (3) (tightening torque: 3.1 Nm

±10%).

6. Ensure that, when retightening the screws, cable strands and the seal

are prevented from being damaged.

7. Reattach the cover of the flange socket (2) to the connector housing

(1) and retighten the two locking screws (4) (tightening torque: 3.1

Nm ±10%).

O-Ring

MG000004v01_MS.fh10

Fig. 18-2: Power connector

Note: The connector output direction can be selected upon ordering

by specifying it accordingly in the type code (output direction A,

B, L, R).

Changing the cable output

direction at

MHD093 – MHD131