Technical data

MHD Sychronous motors Connection System 15-7
DOK-MOTOR*-MHD********-PR05-EN-P
1. Unscrew the heavy-gauge conduit thread (1).
2. Remove the washer (2) and the seal (3).
3. Loosen the housing screw (4).
4. Remove the plug insert (6) from the housing (5).
5. Adjust the seal to the outer diameter of the connection cable.
6. Push the parts (1), (2), (3), and (5) over the connection cable.
7. Unsheath the connection cable and attach the connector sleeves to
the litz wires.
8. Connect the litz wires as shown in the connection diagram.
9. Clamp the outer sheath of the cable under the strain relief clamp (7).
10. Push the plug insert (6) into the housing (5) and fix it using the
housing screw (4).
11. Screw the seal (3), the washer (2), and the heavy-gauge conduit
thread (1) into the housing (5).
12. After having fitted the prepared plug, snap the safety bracket (8) into
place.
Mounting instructions