Technical data

15-4 Connection System MHD Sychronous motors
DOK-MOTOR*-MHD********-PR05-EN-P
Design (1)
1
2
3
L
N
PE
0.75  1.5 mm
2
0.75  1.5 mm
2
NL
I>>I>>
M
Power supply connector
5...8 mm in dia.
Circuit-breaker
Plug connector INS0195
Fan
fanMHD1.fh10
Fig. 15-7: Blower connector type (1)
Connecting and mounting the blower plug
A three-core cable with a connection cross-section of at least 0.75 mm
2
must be used as connection cable.
1
2
3
4
6
7
8
SW17
5
1
2
3
fan_con1.fh10
(1): Housing screw
(2): Plug housing
(3): Plug insert
(4): Flange socket
(5): Screwdriver
(6): Heavy-gauge conduit thread
(7): Washer
(8): Seal
Fig. 15-8: Blower connector type (2)
Proceed as follows to mount the connection cable to the blower plug:
1. Loosen the heavy-gauge conduit thread (6) (size 17).
2. Turn the cylinder screw (1) out of the socket (4) using the screwdriver
(5).
3. Pull off the plug housing (2) including the plug insert (3) from the
flange socket (4).
4. Pull out the cylinder screw (1).
5. Remove the plug insert (3) from the plug housing (2) (see Fig. 15-8).
Electric connection