Technical data

8-2 Connection Techniques Rexroth IndraDyn H
DOK-MOTOR*-MBS-H******-PR02-EN-P
8.2 Power connector
The power connection of the kit-spindle-motor can be made via
• clamping connection (terminal box) or with
• connectors (flange socket).
The power supply from this junction to the drive device can be made via
a power cable. Ready-made connection cables are available from
Rexroth.
The stator is provided with an approx. 1.5m long power cable (flying
leads in a protective conduit). The power cable consists of three power
leads (alt. three pairs of power leads) and two wire pairs for the
thermistors within the end turns of winding.
D
~1500mm
Anschl_E.EPS
D: Diameter cable harness
Fig. 8-1: IndraDyn H cable harness
The cross-sections of the power conductors in the cable harness depend
on the rated current of the motor. In the following table you can find
further details about the cross-section of the conductors.
The cross-section of the wire pairs for the thermistors is 0.25mm²
(KTY84) or 0.5mm² (SNM.150).
Motor frame size
Cross-section of
the power wires
[mm²]
Cross-section of the
control wires
[mm²]
Diameter of the cable
harness (D)
+/- 1[mm]
Minimum bending
radius
static [mm]
MSS102B-0800
MSS102D-0800
MSS102F-0800
2.5
4
10
13
13
22
50
70
130
MSS142B-0700
MSS142D-0700
MSS142F-0700
6
16
16
16
22
22
100
150
150
MSS162B-0400
MSS162D-0400
MSS162F-0400
MSS162J-0400
10
16
16
16
22
130
150
150
150
MSS182A-0100
MSS182B-0280
MSS182D-0260
MSS182F-0200
1
16
16
16
2 x 0.25
2 x 0.5
13
22
22
22
50
150
150
150
Connection wires within the
cable harness