Technical data

Rexroth IndraDyn H Connection Techniques 8-1
DOK-MOTOR*-MBS-H******-PR02-EN-P
8 Connection Techniques
8.1 Notes
Rexroth offers a wide range of ready-made cables for IndraDyn H
motors; these cables are optimally configured for the most diverse
demands.
Decisive advantages of Rexroth ready-made cables are:
• Pre-wired without additional finishing
• Designed for continuous flexing
• Resistant against mineral oils, grease and biologic oils, silicon- and
halogen-free, low adhesion
• Use of licensed cables acc. to UL and CSA
• Burning characteristics fulfill VDE0472-804 requirements
• Compliance of the EMC-guideline and protection class up to IP67
Note:
• Note that self-assembled cables or cable systems of
other manufactures may not fulfill these criteria.
• Rexroth shall not be held responsible for resulting
malfunctions or damage.
• The chosen connectors must be suitable for the DC bus
voltages present.
• The design of the power cable also depends on the control
device used. Please observe the documentation of the
drive device.
You can find additional information ...
• on selecting power and encoder cables for IndraDyn H in the
Documentation “Rexroth Connection Cables”, MNR R911282688
• for assembling cables and plugs, as well as technical data, in the
documentation "Rexroth Connection Techniques, Assembling and
Tools...", MNR R911286117.
• for connection and dimensioning of cooling systems refer to
documentation “ Liquid cooling of Rexroth drive components”, MNR
R911266417
• for “electromagnetic compatibility (EMC) at drive and control
systems” of the same denominator documentation, MNR
R911259814.