Technical data

Rexroth IndraDyn H Assembly Instructions 11-19
DOK-MOTOR*-MBS-H******-PR02-EN-P
Installation Procedure
There are tapped holes on both ends of the stator for attaching the stator
to the spindle housing.
Note: Attachment occurs either on the A- or the B-side of the
stators, but absolutely not on both sides, since a gap between
the stator and the housing is provided for the longitudinal
expansion of the stator during operation.
Note: The basic procedure for attaching the stator to the housing is
always the same. The procedure can vary slightly, however, from that
described here, depending on the construction of the spindle housing.
The following describes how the stator is mounted to the housing.
Proceed as follows:
1. Let the stator glide into the spindle housing so that it is centered.
Use parallel chains or ropes to lift the stator.
Note: Do not use the cable loom as a mounting aid and do not pull
or push the cable loom in any way!
The transport and handling regulations absolutely must be
observed!
Hoisting gear
Lifting eye nut
Threaded rod with
spacer sleeve
Spindle housing
Stator mounted
Stator fastening holes
STATEINBAU2_H_EN.EPS
Fig. 11-19: Installing the stator into the spindle housing
2. Push the stator into its final position. Use suitable tools if assembly is
difficult.
3. Screw the stator onto the end of the housing.
• Secure the screws with LOCTITE 243; see the gluing guidelines in
section 11.3.
• Using a torque wrench, uniformly tighten the screws.