Technical data

11-18 Assembly Instructions Rexroth IndraDyn H
DOK-MOTOR*-MBS-H******-PR02-EN-P
6. If oil is already leaking on the coil end of the step interference fit and
the rotor still cannot be dislodged from the spindle, gently tap the
rotor in the direction of the end stop with a plastic hammer.
11.9 Installing the Stator in the Spindle Housing
Stator Parts / Scope of Delivery
1 brass screw
1 delivery slip
cheese head screws
per DIN 912-12.9
(different numbers and versions
depending upon model)
Grounding cable with terminal end
The following items should also be handy:
GNYE
1 Type plate
Made in Germany
2
S.No.
ROTOR OF 3-PHASE INDUCTION MOTOR
1MR310-123456
1MSxxxxxxx
n max. 4800 min-1
m 111 kg
S.No.
INN 13.09
Stator MRSxx2
LPSTATOR_H_EN.EPS
Fig. 11-18: Scope of delivery of the stator and additional materials
Before Assembly
Installation should be carried out in a dry, dust-free environment. The
following preparatory measures should be taken for this purpose:
• Check to see whether all parts of the delivery are present
• Have additional materials ready. The precise dimensions of these
materials are noted in the construction drawings.
• Visually check the stator for any damage.
• Mount the type plate in a conspicuous position on the spindle
housing.
• Check to make sure that the drill holes for the connections on the
spindle housing are free of burrs; remove these if present.
Note: The inside edges of the drill holes must be absolutely free of
all burrs so as not to damage the stator during installation.