Technical data

Rexroth IndraDyn H Assembly Instructions 11-15
DOK-MOTOR*-MBS-H******-PR02-EN-P
Note: The step interference fit can be placed under a full load only
after 24 hours!
10. Seal both pressure oil connections with threaded pins and secure
them with LOCTITE 620.
compressed air
oil drain
OELAUSPRES_H.EPS
Fig. 11-13: Using compressed air to force oil out
11.7 Balancing the Rotor
The rotor must be balanced with the spindle to achieve the desired
vibration severity grade of the spindle. There are balancing rings with
tapped holes on the front of the rotor. Threaded pins should be screwed
in as needed for balancing. Fig. 11-15 lists the threaded pins that are
supplied.
The vibration severity grade needed depends on the finishing accuracy
of the motor spindle; this accuracy is determined by the builder of the
motor spindle.
Note: No material may be removed from the balancing rings when
balancing the spindle!
mit LOCTITE 620 sichern
secure with LOCTITE 620
ROTAUSW_H.EPS
Fig. 11-14: Balancing by inserting threaded pins