Technical data

11-4 Assembly Instructions Rexroth IndraDyn H
DOK-MOTOR*-MBS-H******-PR02-EN-P
11.2 Aids for Assembly and Disassembly
Tools and equipment
Mount rotor to spindle Dismount rotor from spindle Mount stator Elec. test of motor spindle Remove stator
Crane (size sufficient for weight of part) xxx x
Lifting device (sufficient size for weight of part) xxx x
Work fixture for attaching rotor
1
) x
Warming cupboard ( +150°C minimum) x
Refrigerator (-20°C) x
Balancing equipment x
Test assembly to check concentricity x
Clamping device for fixing spindle-rotor
1
) (x)
Compressed air deviced (x)
Oil pump (max. 1500bar) with accessories
1
) (x) x
Arresting device
1
) x
Drilling device x
Water pump to check tightness (up to 6 bar) x
Ohmmeter x
High-voltage testing equipment x
Inductance measuring equipment x
Torque wrench up to 35Nm x
Conventional tools and cleaning equipment xxx x
Aids
LOCTITE 243 x
LOCTITE 620 x
LOCTITE quick clean 7061 xx
LOCTITE activator 7649 xx
Mineral oil: viscosity 300 mm²/s at 20°C (x)
Mineral oil: viscosity 900 mm²/s at 20°C x
Oil, conventional type, for lubrication x
Grease, conventional type xx
Vaseline x
Coolant x
1
) See explanations on next page.
(x) Only applies to mounting errors
Hilfsmittel.EPS
Fig. 11-2: Aids for assembly/disassembly
Note: Use only suitable tools and equipment!