CONTENTS 2 OVERVIEW � OVERVIEW 3 � MAIN FEATURES 4 � SAFETY PRECAUTIONS 5 � PACKAGE CONTENTS 7 � DESCRIPTION 8 � TESTING YOUR NO BARK COLLAR 14 � TO RECHARGE THE BATTERY 16 � FITTING THE COLLAR 18 � MAINTENANCE 18 � TROUBLESHOOTING 19 � FREQUENTLY ASKED QUESTIONS 20 � WARRANTY AND REPAIR 22 OVERVIEW Thank you for purchasing the dogtra “No Bark Collar” Model YS300! This product has been specifically designed to prevent your dog from barking excessively by emitting an au
MAIN FEATURES MAIN FEATURES SAFETY PRECAUTIONS � Non-electrical stimulation vibration (P) warning prior to the stimulation. Your dogtra “No Bark Collar” is a valuable training aid when used correctly. � 6 intensity levels (2-7) for a wide variety of dispositions. � Test Mode (T) for testing the No Bark Collar. � Rechargeable 2-hour rapid charge Lithium Polymer Battery.
SAFETY PRECAUTIONS No Bark Collars are intended for the sole purpose of preventing the dog from barking. Do not attempt to test dogtra No Bark Collars on humans or other animals. Dogs should be in good health during this collar training. No Bark Collars are not intended for use on dogs weighing less than 10 pounds or less than 6 months of age. If you have any concerns, please consult with your trainer.
DESCRIPTION DESCRIPTION DESCRIPTION Collar strap ON-OFF & Intensity Dial Battery Charging Receptacle and Rubber Plug Contact Points The ON-OFF & Intensity Dial on the collar is used to turn the “ ” on and off, to select the intensity level, and to test the . Set the ON-OFF & Intensity Dial on the “OFF” position to turn off the “ ” ON-OFF & Intensity Dial On pager mode (P) the collar will only vibrate. Level 2 is the lowest electrical stimulation and Level 7 is the highest.
DESCRIPTION DESCRIPTION Set the ON-OFF & Intensity Dial on the test mode (T) to test the . (See “TESTING THE NO BARK COLLAR” on page 14.) ON-OFF & Intensity Dial Function OFF Power OFF P Vibration only (non-stimulation) 2~7 Vibration followed by stimulation T Test mode NOTICE When first using the “dogtra YS300”, it is recommended that you start with the lowest level. If the dog continues to bark, gradually increase the intensity level.
DESCRIPTION DESCRIPTION Contact Points Collar Strap Adjust uses surgical stainless steel contact points. The length of the contact points should be well-fitted so that the contact points are held firmly against the dog’s skin. IMPORTANT : Avoid touching the Contact points unless the No Bark Collar is completely discharged, or you may feel the electrical stimulation yourself.
TESTING TESTING YOUR NO BARK COLLAR TESTING 2. Test by scratching the rough surface of the test tool on the collar (as shown in the diagram) using a coin. The collar will emit a vibration three times. Repeat the same process if you want to test again. 3. The Dogtra YS300 has a preset delay of 15 seconds in-between corrections. Once the unit activates, it WILL NOT activate again until 15 seconds has gone by.
TO RECHARGE THE BATTERY TO RECHARGE THE BATTERY TO RECHARGE THE BATTERY 110-Volt Charger Wall Outlet 1. Open the Battery Charging Receptacle & Rubber Plug on the No Bark Collar and connect the Lithium Polymer Charger to the battery-charging receptacle as shown in the diagram. 4. When the battery is recharging, the LED will stay on red. The LED light will become green when the battery is completely recharged. (The battery is fully charged with a 2-3 hour charge.
FITTING THE COLLAR FITTING THE COLLAR The collar strap should be adjusted so that the contact points are held firmly against the dog’s skin. Fasten the collar enough to allow one or two fingers to fit between the collar strap and your dog’s neck. TROUBLESHOOTING TROUBLESHOOTING My dog keeps barking. Is the No Bark Collar working properly? � Check and see that the Dogtra No Bark Collar is turned on. � Tighten the collar strap and make sure the contact points are held firmly against the dog’s skin.
FREQUENTLY ASKED QUESTIONS FREQUENTLY ASKED QUESTIONS 1. How long does it take to fully recharge the batteries, and how long do the batteries last after a charge? uses Lithium Polymer Batteries, which provide a rapid charge. It takes 2~3 hours to recharge the batteries if the batteries are fully discharged. The LED indicator light stays on red while the battery is being charged, and the light will change into a green color and stay on without blinking when the battery is completely charged.
WARRANTY AND REPAIR WARRANTY AND REPAIR 1-Year Comprehensive Warranty Dogtra Company provides the original purchaser with a 1-YEAR WARRANTY for the iQ Series, EF 3000 Gold, RR Deluxe, YS300, and YS500. The warranty begins from the date of purchase. For the first year, coverage is for Parts, Labor, and Accessories. After the first year, the cost of Parts, Accessories, Labor fees, and Shipping fees incurred are the customer’s responsibility.
