« FCC » DECLARATION OF CONFORMITY FCC rules – PART 15 NUM’AXES declares that the equipment below: Electronic Dog Fence DOGTEK EF-4000 complies to all dispositions of the part 15 of the FCC rules This device complies with part 15 of the FCC. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including interferences that may cause undesired operation.
FREEDOM, SAFETY AND PEACE OF MIND WARNING The device complies with Part 15 of the FCC rules. Any technical changes or modifications on the receiver collar or on the remote control not expressly approved by the manufacturer shall void the user’s authority to operate the equipment. Thank you for choosing an appliance from the DOGTEK range. Before using your EF-4000, please read the instructions in this guide and keep it for future reference.
INSTRUCTIONS FOR USE Composition of the product Inside the packaging you will find: - 1 transmitter unit - 1 power adapter - 1 receiver collar fitted with short contact points and a 30” strap - 1 set of long contact points - 1 CR2 3-Volt battery - 1 test lamp - 1 reel of 18 AWG antenna wire (330 feet) - 1 connection kit including 3 antenna wire connectors and transmitter connector - 1 set of 10 flags - This user’s guide Diagram # 2: Receiver collar (from below) Diagram # 1: Transmitter unit Battery posi
transmitter and connecting to the mains. (See Diagram # 1) The antenna wire For the system to operate, the wire should be connected to the transmitter and form an uninterrupted loop. Both wires must be spaced 6/7 feet apart to avoid cancelling the signal. Either a 18 AWG wire or a 16 AWG can be used, or combined, with no effect to performance. From the transmitter unroll the wire around the perimeter of your property.
a) An initial warning zone (beeps) Adjustable area from 20 feet to 15 inches (approx) on each side of the wire by using the central knob located on the front of the transmitter. A graduation from 0 to 10 helps you define the width of the zone according to your needs (0 = 1 foot; 10 = 20 feet) (See Diagram # 1). b) A second, impulse zone Adjustable based on 3 fixed pre-set positions: approximately 5 feet ●))), approximately 2.
Setting the impulse intensity The EF-4000 collar is equipped with 8 modes so you can adapt the level of impulses to the size and sensitivity of your dog. To change the mode, the collar must be switched on (battery in its housing). Opening the battery cover gives you access to the push button indicated by a pointer (See Diagram #2). To activate this push button, use a pointed object such as a pencil tip.
Replacing the battery of the collar DOGTEK recommends using the same type and same brand of batteries as those supplied in your new purchased device. Other brand of batteries might not operate, or not be compatible or alter the performances of your collar. The right batteries can be purchased from DOGTEK or from our distributor. Unscrew the 4 screws on the battery cover and remove the old battery. Insert the new battery in the position indicated on the plastic casing.
METHOD AND TRAINING / ADVICE AND INFORMATION Introducing the control collar The introduction period can begin for a young dog at the age of 6 months, after completion of basic training. Do not put the collar on an animal in poor health (heart condition, epilepsy, etc.) or which has behavioral problems. He will need to get used to wearing the collar: leave it on him without using it for several days.
• • • • • • • • • Carefully check that your collar is operating properly if it has not been used for some time. Before each use check the tightness of the contact points. Take care not to store or keep your collar in places exposed to high temperatures, like the parcel shelf of a car. Before fitting the collar, you must have your dog examined by a veterinary surgeon to ensure he is suited to wearing a control collar. The system activates automatically as soon as the animal crosses the unauthorized zone.
Technical information Transmitter Power Watertightness Use temperature Dimensions L x H x D 120 V AC Showerproof only between - 4°F and 104°F 3.6” x 1.7” x 4.5” Collar Power Battery lifetime Watertightness Use temperature Dimensions L x H x D Weight Collar adjustable to neck sizes 1CR2 lithium 3V battery about 6 months on standby waterproof between - 4°F and 104°F 2.3” x 1.3” x 1.
Collection and recycling of your device at the end of its life The pictogram which appears on your product means that this one can not be thrown with household refuse. You have to bring the device to a collection location suitable for treatment, development, recycling of electric wastes or bring it back to your distributor. Adopting this process, you do something for the environment, you contribute to the preservation of natural resources and the protection of human health.
