Instructions / Assembly
1/4
Hang the
door on
the track.
Note: If installing soft close hardware, it is best
done prior to hanging the door. Refer to separate
instructions for soft close installation.
If opting to use the
“U Channel” floor guide,
skip Step 6 and
proceed to Step 7.
If opting to use the
“T” floor guide, your “T” floor guide, your
contractor should
route a groove in the
bottom of your door
and install “T” guide
as shown in the image
at right.
Install the adjustable
“U Channel” floor guide
“U Channel” floor guide
flush with the edge of
your door opening, and
spaced from your wall
such that the door hangs
parallel with your wall.
Slide both left and right stops to
the desired locations on the
track, and then tighten in place
with small screws provided.
Then rotate the
anti-jump discs towards
the back of the door.
FINAL STEP - Install the plugs into the
small holes at each of the track.
Congratulations! You have successfully
installed your sliding barn door!