Please read this entire guide before operation
Important Notice: Charging the Receivers • The receivers contain a 'lithium polymer battery' meaning it has a large capacity for its physical size but also requires very specific battery management and charging. • If the battery is completely discharged (flat), it must first to go through an 'initialize cycle' before it is ready to accept a charge.
Table of Contents: Product Description............................................................1 Main Features....................................................................1 Package Contents..............................................................2 Installation of fence system................................................2 Verify the function of fence system.......................................3 Put collar receiver on your dog.............................................
1.Product Description This electronic pet fence system EF168 is reliable, cost-efficient pet containment systems. The harmless radio signal was issued by transmitter and go through the wire to be boundary of the “yard”, when your dog approaches the boundary beyond setting range, the receiver collar in dog neck will start up with a warning beep at first.
. Speed Detect Anti-Run through: The faster your dog is moving, and the higher level of shock or vibration intensity is issued. 6. Multiple Collar Operation: Add as many collars as you like to contain as many animals you have. There is no limit to the number of collars it can control. 7.Up to 5000 square meters range (over 1.24 acre). 3.Package Contents: 4.Installation of fence system To make sure the normal operation of the fence system, you should design a diagram of the fence system at first.
Step 2: Install the boundary flags and Connect the wire Connect one terminal of the wire to transmitter firstly, mount the boundary flags one by one according to the boundary layout, and make sure the wire go through the hole of flags meanwhile. Until all the flags has been mounted properly along the boundary and come back to the transmitter. Please keep the excess wire around the bobbin and connect the terminal of wire to transmitter. Notice: the packed. wire length of is 200 meters. you can add more.
Set the transmitter signal power level: DOWN UP 5.Verify the function of fence system This product has three levels of function adjustable: the first level is only vibration function, the second level is weak static shock function, the third level is strong static shock function. (There is a warning beeper prompt for each level.) Press the button on the transmitter and to change the control range. According to the comparison table above, such as: level 10.
Notice: Don’t place the receiver collar on your dog until the fencing system has been tested and the signal field adjusted. You must manually test the containment system to verify that the signal is properly transmitted trough the wire. Use the supplied test light. 6.Put the receiver collar on your dogs Place the collar around the dog’s neck with the receiver box under the chin. The collar must be on relatively tight to keep the probes making shin contact without restricting breathing.
4. It flashing light double red when charging, it light on green when full charge, turn off the charge it return to shutdown status. 5.Receiver collar will automatic go to standby when collar stationary 60S (power save function), and then shake the collar will be go to work. 6.The receiver collar works: 20S continuous electric shock + 5S stop work, and then stop shock after 5 cycles, flashing red light until dogs return to safety area. 7.How the correction works 1.
9.Troubleshooting Guidelines A.Dog is not responding to correction, pay attention below points: 1.Check the collar strap and make sure it’s proper tightness. 2.Trim the dog’s hair or use rubber probes to make better skin contact. 3、If receiver collar is low battery, charge it. B.System Test Procedure: Whenever you experience a malfunction, you will need to do a Test Loop to determine which component-collar, wall transmitter, or yard wire-is not working. To perform the Test Loop procedure: 1.
3.Don’t wear the receiver collar on dog’s neck more than 10 hours each time. 4.Keep the receiver collar away from your child to avoid accidental injury. 5.Please read the manual carefully before using.
