User Manual

Doepfer Musikelektronik GmbH
User manual V1.0
REGELWERK V1.2
Status Data byte(s) Description
D7----D0 D7----D0
13.1 Channel Voice Messages
•
1000cccc 0nnnnnnn Note Off event.
0vvvvvvv
−
This message is sent when a note is released (ended).
−
(nnnnnnn) is the note number.
−
(vvvvvvv) is the velocity.
•
1001cccc 0nnnnnnn Note On event.
0vvvvvvv
−
This message is sent when a note is depressed (start).
−
(nnnnnnn) is the note number.
−
(vvvvvvv) is the velocity.
•
1010cccc 0nnnnnnn Polyphonic Key
0vvvvvvv Pressure(Aftert.)
−
This message is sent when the pressure (velocity) of a previously triggered note changes.
−
(nnnnnnn) is the note number.
−
(vvvvvvv) is the new velocity.
•
1011cccc 0ccccccc Control Change.
0vvvvvvv
−
This message is sent when a controller value changes. Controllers include devices such as pedals
and levers. Certain controller numbers are reserved for specific purposes. See Channel Mode
Messages.
−
(ccccccc) is the controller number.
−
(vvvvvvv) is the new value.
•
1100cccc 0ppppppp Program Change.
−
This message is sent when the patch number changes.
−
(ppppppp) is the new program number.
•
1101nnnn 0ccccccc ChannelPressure(Aftert)
−
This message is sent when the channel pressure changes. Some velocity-sensing keyboards do
not support polyphonic after-touch. Use this message to send the single greatest velocity (of all the
currently depressed keys).
−
(ccccccc) is the pressure value.
•
1110nnnn 0lllllll Pitch Wheel Change.
0mmmmmmm
−
This message is sent to indicate a change in the pitch wheel. The pitch wheel is measured by a
fourteen bit value. Center (no pitch change) is 2000H. Sensitivity is a function of the transmitter.
−
(llllll) are the least significant 7 bits.
−
(mmmmmm) are the most significant 7 bits.
13.2 Channel Mode Messages (See also Control Change, above)
•
1011nnnn 0ccccccc Channel Mode Messages.
13 MIDI 1.0 Specification: