Owner's manual

A-113

Subharmonic Generator

System A - 100

doepfer

4. In / Outputs

! In

Socket

is the subharmonic generator’s audio input.

Connect up the signal you wish to use as master

frequency signal (normally the rectangle output of a

VCO).

" Foot Ctr. In 1 • § Foot Ctr. In 2

The gate inputs " and § are used to select the

mixture. Any gate type signals may be used (e.g. Foot

Controller, Sequencer gate outputs, MIDI interface)

(see fig. 7).

Fig. 7: Selecting mixtures with gate signals

(0: gate = low or no gate signal applied,

1: gate = high)

The mixture is displayed with the decimal points (see

chapter 3, fig. 5).

$ Single Out

Sockets " outputs the single subharmonic of the

respective frequency divider. The attenuators

do not

affect the level at these sockets.

% Mix Out

At output § the mix of the 4 subharmonics adjusted

with the 4 attenuators

is available.

Foot Ctr.

In 1

Foot Ctr.

In 2

Mixture Display example

00"00"

01"01"

10"10"

11"11"