Installation Instructions

Table Of Contents

WPS

TP-link

The system LED will stay on after

power on, the machine will work

normally.

When the machine is in WISP or AP

mode and the Internet connection is

correct. The Internet LED is

on,other wise it is off.

This LED light works, indicating a

proper connection between the

repeater and the router.

When network cable is connecting,

the LED will ﬂash quickly, otherwise

it will be off.

Press and hold the reset key for 5

seconds, the system will be reset.

Short press, LED ﬂashing playful.

The connection is always on when

the connection is normal

admin

TP-link

PAGE 1
TP-link admin The system LED will stay on after power on, the machine will work normally. When the machine is in WISP or AP mode and the Internet connection is correct. The Internet LED is on,other wise it is off. This LED light works, indicating a proper connection between the repeater and the router. TP-link When network cable is connecting, the LED will ﬂash quickly, otherwise it will be off. WPS Press and hold the reset key for 5 seconds, the system will be reset.
PAGE 2
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.