Specifications

5.6
Electrical System
Note: If a cell phone or a two-way radio has been
retrofitted without complying with the manufacturer’s
installation requirements, the vehicles warranty may be
voided.
5.7 Connection of the Clearance
Lamps
The clearance lamps must be connected to the end
connector J16 by a cable 6mm
2
, rd and an additional fuse
10A. The fuse output must be connected to the terminal
87 of an additional relay for the clearance lamps by a
cable 1.5mm
2
, rd. The terminal 30 of this relay must be
connected to the front and rear clearance lamps by a twin-
connection.
To control the additional relay, the cable 1.5mm
2
gr/gn rd
must be branched at the existing relay K140, terminal 87a
and connected to the additional relay, terminal 86. The
terminal 85 of the additional relay must be connected to
the ground connection W5.1 (see wiring diagram).
Operating cell phones or other radio tele-
communications equipment with an aerial inside
the vehicle can interfere with the operation of the
vehicle and cause a safety hazard.