Specifications

1.6
General Information
CMVSS, identify certain requirements and certification
responsibilities for the various stages of vehicle
manufacturing. Therefore, Body Builders and Dealers
need to review all regulatory requirements carefully to
ensure compliance with applicable standards.
Please consult with an attorney to ensure compliance with
applicable laws or standards.
1.3.3.1 FMVSS 101 / CMVSS 101
This vehicle, when completed, will conform to Standard
101, Controls and Displays, provided that no alterations
are made to the vehicle controls, which are installed on
the vehicle and covered by the standard. Alterations
include location identification and/or illumination of the
controls.
1.3.3.2 FMVSS 102 / CMVSS 102
This vehicle, when completed, will conform to Standard
102, Transmission Shift Level Sequence, Starter Interlock
and Transmission Braking Effect, if no alterations are
made to the transmission, transmission controls,
connecting linkages and cables, starting motor wiring or
plumbing, neutral safety switch and ignition or equivalent
switch and related wiring, or shift level position
identifications.
1.3.3.3 FMVSS 103 / CMVSS 103
This vehicle, when completed, will conform to Standard
103, Windshield Defrosting and Defogging Systems, if no
alterations are made to the windshield defrosting and
defogging systems, controls, wiring plumbing, vehicle
heater assembly, or the airflow to the windshield.
1.3.3.4 FMVSS 104 / CMVSS 104
This vehicle, when completed, will conform to Standard
104, Windshield Wiper and Washing System, if no
alterations are made to the windshield wiper arms, blades,
washer, control, wiring, or plumbing.
1.3.3.5 FMVSS 105 / CMVSS 105
This vehicle, when completed, will conform to Standard
105, Hydraulic Brake System, if none of the gross axle
(GAWR) or gross vehicle weight ratings (GVWR)
are
exceeded, or if no alterations are made to affect the
braking system, hydraulic system components and
fittings, the anti lock system components or electrical
circuitry, tire size, or wheelbase. In addition, the center of
gravity after modifications, or the combined centers of
gravity of all added items by subsequent manufacturers
must conform to requirements of Section 1.8.1 of the Body
Builders Information Book on Calculation of Center of
Gravity after Modifications.