Specifications

Symptom:
P0105-INTAKE PRESSURE SENSOR SIGNAL VOLTAGE TOO LOW
When Monitored and Set Condition:
P0105-INTAKE PRESSURE SENSOR SIGNAL VOLTAGE TOO LOW
When Monitored: With the ignition on.
Set Condition: Intake Pressure Sensor Signal voltage is 0.2 volt or lower.
POSSIBLE CAUSES
INTERMITTENT CONDITION
INTAKE PRESSURE SENSOR 5 VOLT SUPPLY CIRCUIT OPEN
INTAKE PRESSURE SENSOR
INTAKE PRESSURE SENSOR SIGNAL CIRCUIT SHORTED TO GROUND
INTAKE PRESSURE SENSOR SIGNAL AND GROUND CIRCUITS SHORTED TOGETHER
ENGINE CONTROL MODULE
INTAKE PRESSURE SENSOR SIGNAL CIRCUIT OPEN
TEST ACTION APPLICABILITY
1 NOTE: If DTC P1611, P2306 or P2332 is present with this DTC, diagnose
DTCs P1611, P2306 or P2332 before diagnosing this DTC.
Turn the ignition on.
With the DRB, read the Intake Pressure Sensor voltage.
Is the voltage below 0.3 volt?
All
Yes → Go To 2
No → Go To 8
2 Turn the ignition off.
Disconnect the Intake Pressure Sensor harness connector.
Turn the ignition on.
Measure the voltage between ground and the Intake Pressure Sensor 5-Volt Supply
circuit at the Intake Pressure Sensor harness connector.
Is the voltage above 4.9 volts?
All
Yes → Go To 3
No → Repair the Intake Pressure Sensor 5-Volt Supply circuit for an
open.
Perform ROAD TEST VERIFICATION - VER-2.
31
DRIVEABILITY - DIESEL