Specifications

Symptom List:
P2240-ABS STEERING ANGLE SENSOR CAN MESSAGE IMPLAUSI-
BLE 1
P2240-ABS STEERING ANGLE SENSOR CAN MESSAGE IMPLAUSI-
BLE 2
Test Note: All symptoms listed above are diagnosed using the same tests.
The title for the tests will be P2240-ABS STEERING ANGLE
SENSOR CAN MESSAGE IMPLAUSIBLE 1.
POSSIBLE CAUSES
CAN BUS CIRCUITS OPEN
STEERING ANGLE SENSOR
INTERMITTENT CONDITION
TEST ACTION APPLICABILITY
1 NOTE: If the ECM detects and stores a DTC, the ECM also stores the
engine/vehicle operating conditions under which the DTC was set. Some of
these conditions are displayed on the DRB at the same time the DTC is
displayed.
NOTE: Before erasing stored DTCs, record these conditions. Attempting to
duplicate these conditions may assist when checking for an active DTC.
NOTE: This DTC indicates a communication problem between the Steering
Angle Sensor and the ECM.
Turn the ignition on.
With the DRBIIIt, erase ECM DTCs.
Perform several engine run cycles, turning the ignition off for at least 20 seconds
between each engine run cycle.
With the DRBIIIt, read the ECM DTCs.
Did this DTC set again?
All
Yes → Go To 2
No → Go To 3
2 Turn the ignition off.
Disconnect the Steering Angle Sensor harness connector.
NOTE: This code can be caused by an intermittent problem in the wiring
and connectors to the Steering Angle Sensor. Inspect the Steering Angle
Sensor harness connector and associated wiring for signs of poor terminal
contact.
Turn the ignition on.
Measure and note the voltage of both CAN Bus circuit at the Steering Angle Sensor
harness connector.
Is the voltage between 2.2 volts and 2.8 volts for each measurement?
All
Yes → Test Complete.
Perform ROAD TEST VERIFICATION - VER-2.
No → Repair the CAN Bus circuit(s) for an open.
Perform ROAD TEST VERIFICATION - VER-2.
190
DRIVEABILITY - DIESEL