Specifications

Symptom:
P1612-IGNITION VOLTAGE - VOLTAGE ERROR
POSSIBLE CAUSES
CHECK THE ECM POWER AND GROUNDS
ENGINE CONTROL MODULE
INTERMITTENT CONDITION
TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIIIt, erase ECM DTCs.
Perform several engine run cycles, turning the ignition off for at least 20 seconds
between each engine run cycle.
With the DRBIIIt, read the ECM DTCs.
Did this DTC set again?
All
Yes → Go To 2
No → Go To 3
2 Refer to symptom Checking the ECM Power and Grounds.
Are the ECM Power and Ground circuits o.k.?
All
Yes → Replace the ECM in accordance with the Service Information.
Perform ROAD TEST VERIFICATION - VER-2.
No → Repair as necessary.
Perform ROAD TEST VERIFICATION - VER-2.
3 WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
With the engine running at normal operating temperature, monitor the DRB
parameters related to the DTC while wiggling the wiring harness. Look for param-
eter values to change and/or a DTC to set.
Review the DTC When Monitored and Set Conditions. If possible, try to duplicate the
conditions under which the DTC was set.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspectthe related wiring harness connectors. Look forbroken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
All
Yes → Repair as necessary.
Perform ROAD TEST VERIFICATION - VER-2.
No → Test Complete.
99
DRIVEABILITY - DIESEL