Specifications

Symptom:
P1611-SENSOR SUPPLY 1 VOLTAGE IS TOO LOW
When Monitored and Set Condition:
P1611-SENSOR SUPPLY 1 VOLTAGE IS TOO LOW
When Monitored: With the ignition on.
Set Condition: The ECM detects a short to ground on the APP Sensor 5-volt Supply
circuit or the CMP Sensor 5-volt Supply circuit.
POSSIBLE CAUSES
APP SENSOR
CMP SENSOR
VISUAL WIRING AND CONNECTOR INSPECTION
INTERMITTENT CONDITION
SENSOR SUPPLY 1 SHORTED TO GROUND
ACCEL PEDAL POSITION SENSOR 5-VOLT SUPPY CIRCUIT SHORT TO SENSOR GROUND CIR-
CUIT
CAMSHAFT POSITION SENSOR 5-VOLT SUPPLY CIRCUIT SHORTED TO SENSOR GROUND
CIRCUIT
ENGINE CONTROL MODULE
TEST ACTION APPLICABILITY
1 NOTE: If the ECM detects and stores a DTC, the ECM also stores the
engine/vehicle operating conditions under which the DTC was set. Some of
these conditions are displayed on the DRB at the same time the DTC is
displayed.
NOTE: Before erasing stored DTCs, record these conditions. Attempting to
duplicate these conditions may assist when checking for an active DTC.
Turn the ignition on.
With the DRB, erase ECM DTCs.
Turn the ignition off for 10 seconds.
Turn the ignition on.
Monitor the DRB for ECM DTCs.
Did this DTC set again?
All
Yes → Go To 2
No → Go To 8
2 Turn the ignition off.
Visually inspect the wiring and connectorsassociated withtheAPP and CMPSensors
for problems that may result in a short circuit.
Were any problems found?
All
Yes → Repair or replace wiring/connectors as necessary.
Perform ROAD TEST VERIFICATION - VER-2.
No → Go To 3
96
DRIVEABILITY - DIESEL